Spectracal HP DreamColor Z27x Manuel d'utilisateur télécharger pdf

17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA

Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com

HP DreamColor Z27x

CalMAN Setup Guide

CalMAN Display Calibration Software can automatically create an optimized calibration 1D LUT and color

matrix for the DreamColor Z27x monitor and automatically load the calibration data into the monitor.

Because of the inherent linearity of the DreamColor monitor, very accurate performance is obtained

without employing a 3D LUT.

Note: the DreamColor Z24x monitor does not contain the features required to enable CalMAN auto

calibration.

Required CalMAN Software Version:

 Version 5.3.5 or newer

Recommended CalMAN Workflow:

 Monitor - Direct (EIZO/HP)

DreamColor Z27x Control Connection:

 USB 3.0 (USB 3.0 A to B cable required for proper connection and control)

DreamColor Z27x Initial Setup

To connect a DreamColor Z27x to a host calibration computer with a USB 3.0 cable:

1. Install the SDK/API USB driver for the DreamColor Z27x (available from the HP web site).

2. Connect a USB 3.0 cable between the display and the CalMAN computer (a USB 3.0 cable is

required).

3. On the DreamColor Z27x, under Open Menu / Management / Manage Internal Processor, select

“Enable.”

4. On the DreamColor Z27x, under Open Menu / Image Adjustment, uncheck the “Use Video Levels

(16-235)” selection. After calibration is complete, you can select the Video Levels option, if

desired.

5. Cycle the master power switch on the rear panel of the DreamColor Z27x, and then wait 2

minutes before connecting to the DreamColor within CalMAN.

DreamColor Z27x Connection Modes

The DreamColor monitor may normally be connected to its signal source in one of two basic modes. The

monitor’s normal connection mode determines the optimum calibration method to use in the following

sections. The two connection modes are:

 Graphics Adapter Connection Mode - Connected to a computer’s standard graphics adapter

output.

 Independent Source Mode - Connected to another signal source (e.g. signal router, video

adapter device, etc.).

1 2 3 4 5 6 7